Set includes 1 ounce bottle each of thick (Maxi-Cure TM), medium (Insta-Cure+ TM) and thin (Insta-Cure TM) Cyanoacrylate Glue and Debonder (Un-Cure TM) and 2 ounce bottle of Accelerator (Insta-Set TM).

Insta-Cure (TM) is the thinnest viscosity CA glue offered by BSI. It has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Thin CAs work very well on soft, porous woods since they penetrate into the wood and form more than just a surface bond.

Insta-Cure+ (TM) is BSI’s medium or higher viscosity CA glue for loose fitting joints or filling small gaps.

Maxi-Cure (TM) is BSI’s thickest viscosity CA glue and is the best CA for most plastics, making it the perfect choice for plastic model assembly. When used with INSTA-SET (TM) activator, it works better than any putty for modifying or filling voids. When dry, it can be carved with a knife or razor blade and sanded and feathered to form a finish indistinguishable from plastic. MAXI-CURE (TM) also bonds fiberglass, hardwood, metal and rubber better than any other hobby adhesive. INSTA-SET (TM) is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.

INSTA-SET (TM) is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.

UN-CURE TM) debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE (TM) will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure (TM) on plastics.

WARNING: Cancer and Reproductive Harm -