Some of the most important adjustments you can make to your table saw are to ensure your fence and blade are parallel to your miter slot, there is no blade runout, and your arbor is running true. You will not believe how well your table saw will cut when the above adjustments are performed accurately. In addition, getting your blade and fence parallel to your miter slot will improve the safety of your saw by minimizing kickback. This jig can also be used to test for router and drill press run out and to set your jointer infeed and outfeed tables coplanar and to set knives coplanar to the outfeed table.

This jig is designed and engineered in the USA.

Specifications:

Digital Indicator:

• 1" total travel
• Direct conversion between inch, metric and fractions
• Floating zero (can set zero at any location, even after unit is powered off and back on)
• Absolute zero (can set and recall zero at any location even when powered off) , automatic off after 5 minutes of nonuse,
• Hold function (can hold a measurement)
• Lifting knob (can pull out plunger from back of unit)
• Resolution to 0.0005”, 0.01mm or 1/128”, repeatability to 0.0005”
• Accuracy to 0.001”.
• Uses a standard 3V CR2032 battery that will last for 1 year with moderate use and comes with extra battery.

Miter Bar (the piece that slides in any standard 3/8" x 3/4"  miter slot)

• 6” long with rare earth magnets and spring expansion anvils to keep it tight in the miter slot while also allowing it to slide easily up and down the miter slot.
• Machined from hardened aluminum alloy and anodized and will never rust.

Slider Bar (the piece that mounts to the above Miter Bar)

• 9” x 3/4" and has a 6-3/4" long machined slot to allow adjustment and can be locked down tight with the included hex screw. A hex wrench is included. 
• Allows an indicator to be mounted horizontal or vertical.
• Machined from hardened aluminum alloy and anodized and will never rust.

WARNING: Cancer and Reproductive Harm -